开云体育

I have since learned that there is a small button on the right side of the inboard gear that disengaged it from the main shaft to allow the reduction in speed. Pull it out to disconnect it from the

It is called the “Back Gear” and basically puts the lathe into a sort of compound mode (to borrow an old automotive term). It gives you many lower RPM speeds to use. Asa side benefit it does lock

What does this lever do? (Top center of image). So far, it seems to lock the machine in place by moving 2 gears onto mating gears on the main shaft.Dan

Dan this is what you lathe looked like when it was new. Dennis [email protected]> wrote:

Here are a pair of photos of what I got.Dan

PS: I have a Lot 4 so they should work (?)

Dennis: I have the change gears you gave me. I have never used them in that one part on my lathe I could never get right was the Banjo. Dan (if its alright with you Dennis) I cna pass on this set.

Hi Dan Dalton hever had a manual or at least any that we have ever found. Your best bet is South Bend lathe's how to run a lathe and also the Atlas operation manual. Both are very revallent to the

I have just obtained a Dalton Six Type B-4. I am a complete newbie to machine work but want to learn. I am seeking information about instruction manuals, sources of extra gears for the power feed

Wow this is interesting. First off there is little resemblance of this lathe to the other three prototypes we have seen. For one the other three have four bolts holding the front bearing cap on wear

Tag on coutnershaft that was found with the lathe.? Unknown if it is original or not.

Yahoo Mail: Search, Organize, Conquer

The letter H is an odd designation. We don't have any record of a Model H. There were however two or three prototype 10 1/2 inch swing lathes that have shown up but they have no lot or serial

Dennis?

Where was the auction at? That's probably the only dalton like that known to exist.? Yahoo Mail: Search, Organize, Conquer On Sun, Jul 21, 2024 at 5:05 PM, Grey Pilgrim<pilgrim23@...>

SWEET! All I have is a puny lot 4 missing parts on a old table saw frame powered by a backwards mounted South Bend motor mount.

Hello, the link in the bottom of my post should take you to the album I created in the group. Thanks! [email protected]> wrote:

You want the cast iron Yahoo Mail: Search, Organize, Conquer On Sun, Jul 21, 2024 at 2:57 PM, Grey Pilgrim<pilgrim23@...> wrote: Pics would help? Welcome to the clan

Pics would help Welcome to the clan