On Oct 16, 2021, at 4:16 PM, glenn brooks <brooks.glenn@...> wrote:

Bryan,

Here are a couple more photos of my Dalton tensioning setup.

Also shows a method I made up to level the bed. The dalton mounting casting is bolted to two lengths of 1/4” flat bar. ?The flat bar is bolted to the table and threaded somThe hex headed bolts protruding out of the flat bar allow front and back off the lathe ?to be raised or lowered individually, as needed, to take the twist out ?of the bed. ?The tailstock end is bolted solidily to table.

<image1.jpeg>

?

<image2.jpeg>

<image3.jpeg>

<image4.jpeg>

<image5.jpeg>

On Oct 15, 2021, at 3:13 PM, glenn brooks <brooks.glenn@...> wrote:

Bryan,

I’ll take a couple of additional photos and post latter today.

Glenn?

On Oct 15, 2021, at 11:15 AM, Bryan Alton via <bryanalton@...> wrote:

Ralph,
? ? ? ? ? thanks for the link, shame it's not something I could buy here in the UK.

Regards

? Bryan