Thanks for the reply. I did a semi accurate measurement last night and thats what I came up with also.? Thanks again cheers.
On Thursday, October 7, 2021, 12:14:42 PM CDT, Grey Pilgrim via groups.io <pilgrim23@...> wrote:
JOHN i asked this very question recently here is Dennis?Turk’s answer:
For the spindle its 1 1/4 - 12 threads per inch. This size is for the Lot 2 3 4 and 5. Lot 6 and the Dalton 9 is 1 7/8 - 8. Not sure what the 10 1/2 inch had as there is only a couple known of and no one in this group has one of the three I know of.
On Oct 7, 2021, at 9:51 AM, John Chromey via <hogsback65@...> wrote:
Can anybody confirm the head stock thread. As near as I can measure It is a 1 1/4x 12 thread. Am I on the right track??? Also if I was to drill and tap the broken tooth what would be the size and should I opt for a harder screw or just a soft tensile one. Thanks again.
