Re: Step pulley mount
¿ªÔÆÌåÓýAs to your question about the tail stock here is how that works.? If you back the tail stock barrel back all the way the lead screw inside the barrel will come up against the small diameter end of the dead center or drill chuck arbor and with a little force on the hand wheel will knock out the tool in the barrel.? We can see by your questions that you have never ran a lathe before so maybe a few you tube videos on lathe operation would be a good thing for you to watch. ? Sent from for Windows 10 ? From: probodybuilder21 via groups.io
Sent: Saturday, August 22, 2020 8:43 AM To: [email protected] Subject: [DaltonLathes] Step pulley mount ? Hey guys I'm trying to restore a dalton t-l I'm trying to figure out how the mount is.suppose to work for the step pulley I have included a photo of the mount it has grooves on the inside and a slot but I dont know how it holds the shaft without bearings keeping the friction down also on the tail stock it.has the.centering spindle can I remove that from the tail stock and put a drill chuck on it I can't get the center out of the shaft? ? |
Dennis Turk
