So I've been operating under the assumption that the tapers on my
lathe are Morse... The tailstock takes and holds Morse #2's very
nicely, plus the lathe came with the Morse fittings which is where
the assumption came from... The thing that is making me wonder a
little is when I tried to slide a #3 in the spindle, I got the sense
that it wasn't quite right... Now of course that might mean I just
need to ream it a bit to clean it up, but thought I'd ask if Dalton
was using one of the other tapers before I go and buy a reamer...
As a side note to Dennis, I got the plates fitting nicely now. Just
had to chase the spindle a hair for whatever reason... Probably a
slightly rolled thread I wasn't seeing. Thanks!
