开云体育

because i don't have them. I have all drivers and crossovers and back panel with conectors, and i don't have the cabinets.

Ahem....why build a pair?

Most of the other measurements are in the files /WIKI sections of this forum.

What kind of measurements are you looking for? Are all the components you have original and functioning? Do you have the assembled crossover? The baffle sizes are: The large panel is 11” wide x

Hello guys! i want to make a pair of dahlquiest dq10 speakers. I have all the components, but i need to make the cabinets/enclosures. Can someone please give me some measurements please? Thank you !

Thanks Pete! You're a good man! So my brother used his high end milling machine to properly mill out the spaces for the new midrange and tweeter. Also had to construct a new tube for the 6" midrange

My marked up schematic shows black/brown going to positive, and black/white going to negative. Please let us know what mods you made and how they sound. Pete

Pete, I'm getting ready to install those new mids we talked about on the DQ20's. Polarity question again...is the brown stripe the positive? Once again no markings on the mid connection. Thank you

I have at least one SEAS MCA15RCY and they are very similar but with the SEAS built on a much nicer cast frame. Both have treated paper cones of about 3.5" to the start of the roll. Both have about

Thanks all for the insights into the stacking questions. I'll need to think on this more. I do like the computer rack and securing to the ceiling suggestions :-) Have a great weekend,

I think I looked at that one too! Crap...I've looked and converted so many mm to inches, I can't remember anymore! Lol. Very nice! Let me know how it works if you pull the trigger. I really like the

Pretty sure that the original was 5.25" and it was a true midrange with short throw and fairly high sensitivity. I'm considering this one, because of many similarities - not sure if it will drop

It's going to be a little router work (my siblings own a very high end cabinet shop). I replaced the non original woofer that it came with, with Advents 12" and the tweeter with the Scanspeak

https://www.madisoundspeakerstore.com/approx-6-7-woofers-hivi/hi-vi-l6-8r-6-woven-cone-woofer-with-phase-plug-8-ohm/ [email protected]> wrote:

Which mids are you getting? These DQ20i s are at our house in Stamford CT and I had the drivers at our home in Trumbull where my measurement equipment is. The Trumbull home burnt down and most of

Pete. Thanks for your reply. Madisound squared me away on polarity. I have so far replaced the woofer and tweeter and ordered mids from Josh at Madisound yesterday. I'm not so much of a purist when

I recently purchased a very clean pair of DQ20i s and am in the process of restoring them. Woofers were recently done by Miller Sound by PO. And I'm carefully documenting them on Audio Karma, and

I’m in the camp that it’s a hobby and it was fun to try. ?Here is my Rube Goldberg low cost stacking method. ?It uses the original base that was reinforced and pipe clamps. ?It was a little

I have never seen a "stacking kit" that wasn't homemade in design and build. That said, you won't find one that's manufactured. But the bigger point I'd make is "why?"? Other than impressing your

I'm away from home so I'm asking for your help. I'm replacing my Magnat mids in my DQ20's and the seller is asking for cabinet hole dimensions. Depth before inner vent tube and cabinet hole size. If