开云体育

I've looked through the "manual" but can't find what I'm looking for.

Does any of the DX Lab programs send the band data to the parallel port?

Pins 2, 7, 8 and 9 are the 4 BCD output pins and pin 18 is their return.
N1MM can use this to control antenna switches and etc.

Thanks,

OK, back in my hole,

Ron, KU7Y
Arizona Outlaws Contest Club
Northern California Contest Club
Silver Springs, NV
ku7y@...

AA6YQ comments below

-----Original Message-----
From: dxlab@... [mailto:dxlab@...]
Sent: Wednesday, February 24, 2016 8:00 PM
To: dxlab@...
Subject: [dxlab] Band data output?

I've looked through the "manual" but can't find what I'm looking for.

Does any of the DX Lab programs send the band data to the parallel port?

Yes, Commander can do that. See

<>"

73,

Dave, AA6YQ

Thanks for the very fast response Dave,



That's just what I was looking for.



OK, back in my hole,



Ron, KU7Y

Arizona Outlaws Contest Club

Northern California Contest Club

Silver Springs, NV

ku7y@...



From: dxlab@... [mailto:dxlab@...]
Sent: Wednesday, February 24, 2016 6:38 PM
To: dxlab@...
Subject: RE: [dxlab] Band data output?

AA6YQ comments below

-----Original Message-----
From: dxlab@... [mailto:dxlab@...]
Sent: Wednesday, February 24, 2016 8:00 PM
To: dxlab@...
Subject: [dxlab] Band data output?

I've looked through the "manual" but can't find what I'm looking for.

Does any of the DX Lab programs send the band data to the parallel port?

Yes, Commander can do that. See

<>"

73,

Dave, AA6YQ