开云体育

When using "QRZ.com via Pathfinder", which requires only a free QRZ account, lookups are rate-limited to one every 4 seconds. For DXers, this limit is only relevant when importing an ADIF or

Has anyone else had my recent experience with multiple "spots" from a single callsign showing up in Spotcollector at the same time. In one instance a Polish station nearly filled the entire

Asi’ es la vida unfortunately. Outlook LT Gil W0MN Hierro Candente Batir de Repente 44.08226 N 92.51265 W EN34rb Sent: Sunday, March 2, 2025 11:31 AM To: [email protected] Subject: Re:

That has been my experience as well. Many ops don't maintain their HamQTH listing being unaware that an entry for their callsign existed. If a user wishes to avail themselves of the automation of

Both DXLab Suite and JT Alert can be configured to use HamQTH. However, I have found HamQTH much less complete and less accurate than QRZ.com (even in the "free", non-XML version). 73, ... Joe,

I think HamQTH can do all the same functions. And it's unlimited use is free. But I am not sure if DXLabs can be set up to work with HamQTH. Joe WB9SBD

Works fine but you miss a lot of worthy things on your QRZ page function and get a very limited number of lookups and they are slower. If you have a moderate size or larger log or want to log a lot of

You can look up a very limited number of calls free but if you are keeping a computer log and want to get more than a few at any one time and other functions of the application interface then you must

Dxlab works just fine without having a qrz subscription. There is also a xml subscription that you can get for less then what Gil said.

Gil - I read your post about inflation. I have never subscribed to QRZ, so I had no idea it was that costly. I am curious though, you said "No choice but to subscribe though." Am I missing something

QRZ prices are getting out of hand. No choice but to subscribe though. I remember it went from free to 15 to 25 and now 45+. XML is a requirement for reasonable usage of DXLABAS and I have to

yea, something weird going on......getting a bunch of 80M spots for EU right now and its broad daylight there......and seeing the same thing, I'll get 5 spots from the same station, by 5 different

Has anyone else had my recent experience with multiple "spots" from a single callsign showing up in Spotcollector at the same time. In one instance a Polish station nearly filled the entire

+ AA6YQ comments below When I go into Commander configuration, the selection for Spectrum-Waterfall is grayed out. + Thanks. + During normal operation, Commander does not disable the entire

When I go into Commander configuration, the selection for Spectrum-Waterfall is grayed out.

+ AA6YQ comments below + In the General panel on the General tab of SpotCollector's Configuration window, is the "Capture location info from notes" option enabled? If so, SpotCollector will give

Where are you seeing OC00 in SpotCollector? I see DXGrid of OH29 which matches DXView (OH29mm) as well as the VK9XU entry on QRZ.com (OH29tm). The large difference in heading is because VK9X is

not sure why but if I type in vk9xu in to DXview it shows their grid as OH29 (heading of 334 degrees) BUT if I click on vk9xu in spotcollector it shows their grid as OC00 (heading of 185 degrees) any

+ AA6YQ comments below + To what does the word "that" refer? 73, Dave, AA6YQ

Any reason that should be grayed out? IC-7610