开云体育

Perhaps I’m working FT8 looking for needed calls. JTAlert gives me this info. I may not want to QSY to another frequency/band depending on the “need” for the spotted station. If the spot is

In SpotCollector you can set up the "Need" filter to do exactly that. Set your spot collector display window to show reason for the need [e.g., show columns for need, band, mode, zone, iota, & etc

On Wed, Feb 26, 2025 at 04:29 PM, Dave w6de wrote: > > > > I believe that highlight would be a persisting distraction. I use the band > view in DXView to check my entire band and mode status for

Perhaps I’m working FT8 looking for needed calls. JTAlert gives me this info. I may not want to QSY to another frequency/band depending on the “need” for the spotted station. If the spot is

Understand, but I don’t want to QSY until I see the data shown in the DXView Progress Window and then decide if I want to change bands/modes. + What's the problem with QSYing before you know it's

Understand, but I don’t want to QSY until I see the data shown in the DXView Progress Window and then decide if I want to change bands/modes. I just click the spot in SpotCollector then look at the

Several of my earlier posts and your response are all missing content. Please try again. Thanks! 73, Dave, AA6YQ

+ AA6YQ comments below True, though I believe it is just the band, not the mode, that is highlighted, but the current band is not necessarily the band the spotted DX is on. That is one reason I

True, though I believe it is just the band, not the mode, that is highlighted, but the current band is not necessarily the band the spotted DX is on. ?That is one reason I think having the DX spot

The active band and mode (headings) are already highlighted (bold). 73, ... Joe, W4TV