开云体育

Dear W0MN, While processing your ADIF file for Club Log, the following possible problems were detected. Your log may be correct, but if necessary you can resolve these problems and create a new

Thanks, Joe, for directing me to"PIN" the un-numbered edition of Launcher.exe I will watch for any change, Dave.? It would be simpler to click on a Launcher icon on the START page rather than

+ AA6YQ comments below So, far, this seems to work. There is no file "DXLab Launcher.exe". The are three files; DXLabLauncher, DXLabLauncher197, and DXLabLauncher232 that are "application" type

By default, Windows hides the file extension. DXLabLauncher is DXLabLauncher.exe, etc. Make sure you pin DXLabLauncher(.exe) and not one of the "numbered" versions. 73, ... Joe, W4TV

So, far, this seems to work. There is no file "DXLab Launcher.exe". The are three files; DXLabLauncher, DXLabLauncher197, and DXLabLauncher232 that are "application" type files. Each has the rocket

+ AA6YQ comments below + Using Windows Explorer, navigate to the folder in which your DXLab applications are installed; by default, this is C:\DXLab + Within this folder, navigate to the Launcher

DXLab reports that Launcher is already installed. How do I get at it? [email protected]> wrote:

New Windows 11 computer.? Installed Launcher successfully and used it to download and install all the other DXLab apps.? All the apps have icons in the START menu and work as expected.? Launcher

+ AA6YQ comments below + It may be that another applications has your log file open. Try closing all applications and rebooting Windows; then see if DXKeeper can start and open your log. 73, Dave,

What version of DXKeeper did you last use? Did you update to 17.9.9 or some other version? 73, ... Joe, W4TV

It has been several weeks since I was able to get on the air. DXLab Launcher said things were out of date so I did all the upgrades. DXKeeper said the database needed significant upgrade, so I had it

+ AA6YQ comments below + DXView only attempts to open one COM port, which it uses to control an antenna rotator. Do you have an antenna rotator for DXView to control? If not, uncheck the "Enabled"

Did your rotor come port # change?

I have version 4.6.9 of DXView installed. When I try to open DxView I get the above message and DXView fails to open. Can anyone help me?

Thanks Larry, got everything working…..also port forwarding is not necessary as I mentioned earlier…we have a solid VPN link from home to the remote site so port forwarding does nothing. Thanks

Mark, I have no experience with simultaneous use of VPN and Smartlink, so I can't share any experience with that dual setup. As Dave observed, the CAT protocol does not support spotting data. If you

Just confirming the suggested links provided a correct solution; finished verifying it and very pleased with results. Thanks & 73 de Dave, W5SV

+ AA6YQ comments below + Correct. This is what you're missing by using SmartSDR CAT: http://www.dxlabsuite.com/commander/FlexSigCallsigns.jpg + The remote approach documented by Larry KB1VFU here

Negative, I don’t see active callsigns displayed on the Flex waterfall

+ AA6YQ comments below + There is no functionality in DXKeeper that responds to a double-click in that window. + I suggest that you contact Microsoft Windows support. 73, Dave, AA6YQ