开云体育

+ AA6YQ comments below Very pleased to see this discussion. Sometime back I used a Yeasu FT-920 with SignalLinkUSB to the mike port and worked fine. Recently decided to get back active again but

Very pleased to see this discussion. Sometime back I used a Yeasu FT-920 with SignalLinkUSB to the mike port and worked fine. Recently decided to get back active again but decided to switch to the

+ AA6YQ comments below This may have to do with updates from LoTW. I was told that I only really needed to update my latest call sign with LoTW unless I was entering more Q's from paper logs. +

+ AA6YQ comments below Hi Dave, Let me look again for the radio settings for baud rate, parity, word length, and stop bits that match your radio's settings. I'm not sure what to make of

The only differences between the DXLab Suite and N1MM+ configurations are in the CW/PTT settings and are due to the differences in the way DXLab Suite and N1MM+ do CW/FSK. 73, ... Joe, W4TV

OK, I was working from memory. Off is fine. Yes, if you are using Commander for PTT. See the example configuration for USB Interface II with DLab Suite is the USB II area at

This may have to do with updates from LoTW.? I was told that I only really needed to update my latest call sign with LoTW unless I was entering more Q's from paper logs.? Yes, I may do that someday

Hi Dave, Let me look again for the radio settings for *baud rate* , *parity* , *word length* , and *stop bits* that match your radio's settings. I'm not sure what to make of this: * set the *RTS*

Joe, I have DTR Off (there is not an option for None,) and the RTS choices are Off, On, Tx and Flow. Should I use Tx?

I do not think I do, as there seems to be disagreement in the suggestions in the MicroHam setup for N1MM+ vs DxLabSuite. Currently in Commander config, Port 5, 4800, 8, N, 2 stop bits, DTR Off, RTS

microHAM USB Interface II does not pass RTS/CTS. The radio RTS line is held high ("always on") by the hardware. The UART RTS and DTR "outputs" are used for PTT and CW respectively. In Commander

+ AA6YQ comments below + Step-by-step configuration instructions are here: < https://www.dxlabsuite.com/dxlabwiki/TranceiverControlKenwood> (

Hi Steve, do you have the RTS/CTS flow control options set correctly? -- 73 Bill G4WJS.

MicroHAM USB Interface II is operating correctly, but Commander does not reflect the radio frequency, or anything else. Any suggestions? Thanks, Steve W1LV Here is part of the error log: 2020-06-15

I wasn't sure what I had done to create the enormous queue that I had.? Some of the QSO's went into the 1980's.? It may have been my wanting to add needed ones back 13 years ago.? Since then, I've

+ AA6YQ comments below + When directed to Launch a non-DXLab

Not yet Dave. Doing arrl vhf contest all weekend. 73 doc n4ww

+ AA6YQ comments below Yes they print well. + Did you follow the recommended steps in this post? </g/DXLab/message/194417> 73, Dave, AA6YQ

Yes they print well. doc n4ww

+ AA6YQ comments below I have been off the air for quite a while putting up a new tower and antenna. Today opened DXLab to update what I have missed. I'm told "Unable to open LOTW database