开云体育

I've been getting them too, even though my QRZ page clearly states that I won't confirm the contact that way. Usually there is a comment on the Email QSL that tells you how to respond. Here is my

I am getting more and more online QSLs.? Is there an automated way to respond back to their email address with my filled-out QSL? All suggestions appreciated. John, K2cib

+ AA6YQ comments below + Is there an errorlog.txt file in your SpotCollector folder? + On the Configuration window's "Spot Database" tab, how many entries are shown to be present in your Spot

Hi all, My Spot Collector has stopped working. It was rolling along fine and, a few days ago, it stopped collecting spots. I get spots from 2 spot sources, both Telnet DX Clusters. When Spot

+ AA6YQ comments below You do *not* need to keep the Process Lasso user interface (GUI) running at all times for your rules and optimizations to remain active. Process Lasso is designed with a

The Ham Bands Only check box is replaced by "Dual Track" for some rigs with dual receivers. 73, ... Joe, W4TV

No problem. I know what you mean! 73, Ken, KJ9B Sent: Tuesday, April 29, 2025 12:45 PM To: [email protected] Subject: Re: [DXLab] Commander: Ham Bands Only check box location Thanks, Ken,

Thanks, Ken, sigh. Yes, obvious as can be. I just could not see it staring me in the face. 73 Rich, NU6T [email protected]> wrote:

In the Commander window, the Ham bands only checkbox should appear under the frequency display. If the Commander window has been re-sized, the checkbox might be not visible, perhaps. If your

Do you need to keep Process Lasso running all the time, or can you run it once, set your parameters, and then exit? Thanks, Earl / KD5XB Sent with [Proton Mail](https://proton.me/mail/home) secure

I'm working my way through the manual and help files. Guidance for Commander, section on Changing Frequency (p 50), refers to a check box for "Ham Bands Only.' I have not found the location of that

The override is in the Big Cty file. Tom-KQ5S

# More AA6YQ comments below + Are you referring to the Filter panel at the bottom of the Main window's "Log QSOs" tab? This panel displays the current Log Page Display filter in its caption,

+ Are you referring to the Filter panel at the bottom of the Main window's "Log QSOs" tab? This panel displays the current Log Page Display filter in its caption, e.g. Filter: Call=VK9NS **Yes +

+ AA6YQ comments below + The UDP protocol does not guarantee delivery. You can direct Commander to QSY via messages conveyed via TCP, as described

+ AA6YQ comments below + Are you referring to the Filter panel at the bottom of the Main window's "Log QSOs" tab? This panel displays the current Log Page Display filter in its caption, e.g. Filter:

+ AA6YQ comments below + This is necessary because like TO and TM, TX is an ambiguous prefix; it can be used from several DXCC entities. DXLab provides an "Override List" to enable you to specify

Hello I ended to code an alternative to JT alert which is named "Wait and Pounce". https://sourceforge.net/projects/wait-and-pounce-ft8/ While I read the doc there

DXView -> Config -> Override List ... add an entry for TX9A 73, ... Joe, W4TV

I've been away and finally got to importing 2400 WPX SSB Q's into DXkeeper.? After import I did lotw "add requested" and then 2566 Q's were recorded as sent to lotw.? approx 58000 Q's in the