开云体育

+ AA6YQ comments below

So have I, a bit. And a VERY important issue has been missing from the discussion -- RF NOISE! Monitors and their power supplies are a well-known source of noise on our ham bands, and the last thing

+ AA6YQ comments below + That's a slippery slope: 1. It's not clear that high-end graphics

I've followed this thread with some interest. It seems to me that an important feature of computer, monitor, and graphics cards purchases is missing. I believe one should attempt purchases that

+ AA6YQ comments below + The N1MM-DXKeeper Gateway enables converts a "log QSO" directive received from N1MM via to a "log QSO" directive to DXKeeper, with some added options for callbook lookups and

So a new user of K4-Control for Elecraft by DL8MRE? and trying to get its UDP interface working with N1MM-DXLab Gateway (v1.3.0)? So far no success. In the app settings there is a section for UDP

Selecting a video card may be a bit of an oxymoron these days as the integrated video capabilities on many of the newer systems are more than adequate. For example, the integrated video in the Ryzen

+ AA6YQ comments below An important distinction is that most of the features of these performance graphics cards are not going to be used at all with typical ham applications. Almost nothing in the

An important distinction is that most of the features of these performance graphics cards are not going to be used at all with typical ham applications.? Almost nothing in the ham application use 3D

Henk, thank you. It is not yet clear to me that my system will handle 4K monitors. I need to learn more, but I read that Dell made several design choices in the XPS 8950 that may limit resolutions

Dave, thank you. Beautiful! Rich, NU6T [email protected]> wrote:

+ AA6YQ comments below It was the databases in DXView the caused the problem. + There was no "problem" - you simply forgot to copy or download the eQSL and LoTW databases to your new computer .

+ AA6YQ comments below

+ AA6YQ comments below + Make sure Commander and your IC-7800 are set to the same baud rate. + You don't want "CI-V transceive" enabled, though enabling it would not prevent interaction + Contact

2025-03-25 20:22:08.824 > RadioFreq + theAdjustment = -0.01 2025-03-25 20:22:08.824 > CIVModule.SetXcvrFreq: NewFreq = -0.01, theBand = -1, QSYBand = -1 2025-03-25 20:22:08.824 >

Still trying to get Commander up and running with the Icom 7800. Am using a straight through DB-9 cable. have set the 7800 ci-v to on, ci-v address to 6A in both commander and the 7800 but still

Thanks Dave. What started this is I was looking for a feature that the gateway did not provide so I discussed it with Dave and he asked if I wanted to take a look again at taking over maintenance. We

Thanks Dave It was the databases in DXView the caused the problem. -Kurt, KR2C

Hi to Dave and Stan, Like Stan, that process is OK, but I think I will stick to my "Sticky Notes" on screen, where I keep a list of new ones worked until they are confirmed. For the (now) two new

Hi, The Intel UHD 730 chipset supports 4k resolution. (Max 4096x2160@60Hz). Depending on the motherboard you might not need an additional graphics card. I use a 32 inch 4K monitor. Make sure it