+ AA6YQ comments below
After confirming that the IC-7600 is controlled by DXLabCommander, I went back and redid the settings again, looking at the IC-PW1-controlled DXLab instructions. The previous setup was also set up while looking at this manual.
At this time, I completely disconnected SteppIR from the PC, leaving only the IC-7600 and IC-PW1 connected to the PC.
After setting up, the PW1 alert lights up, and after clicking it, IC-PW1 and IC-7600 can be controlled in conjunction with each other.
+ That's correct behavior
However, if the IC-7600 and IC-PW1 are turned off and then turned on again, the IC-7600 and IC-PW1 will not work together. At this time, the AUTO LED on the IC-PW1 is lit.
Once the power is turned off, the IC-7600 cannot be controlled. It is the same situation as before.
I don't know how to solve this problem. I am in trouble.
+ It sounds like your PW1's programming was not recorded. In?
?
?
+ did you follow step 2, step 3, and steps 7 to 13?
+Did the Input1 light stop blinking in step 10?
+ Did you then power off your PW1 as instructed in step 11?
? ? ? ?73,
? ? ? ? ? ? Dave, AA6YQ
