+ AA6YQ comments below
Even though I remain on a frequency for the defined dwell time,? ?if I change bands and return a bit later, the VFO will go to a different frequency.? For example, I can be on 10123 for a while.? Switch to 40m.? ?Come back to 30 and it will go to 10123.? ? ? The next time, I go to 20 meters and return to 30m, it will go to 10120 even though I have not been on that frequency.??
?
Changing bands via the buttons on the bottom of the Commander Bandspread
+ So that I can see what's going, please do the following:
1. On the Configuration window's General tab, check the "Log debugging info" box
2. Terminate Commander
3. Start Commander
4. Using Commander's Main window, QSY to 7005 in CW and remain there for the specified "Band Stack dwell time" plus 10 seconds;; please use the time displayed in the title bar of Commander's Main window to ensure that you've waited long enough.
?
5. Using Commander's Main window, QSY to 7010 in CW, and remain there for the specified "Band Stack dwell time" plus 10 seconds
6. Using Commander's Main window, QSY to 3510 in CW, and remain there for the specified "Band Stack dwell time" plus 10 seconds
?
7. Using Commander's Main window, QSY to 3505 in CW, and remain there for the specified "Band Stack dwell time" plus 10 seconds
8. In the Band panel at the bottom of? the Bandspread window,
?
8a. click the 40 button, and wait 5 seconds
?
8b. click the 40 button, and wait 5 seconds
8c. click the 80 button, and wait 5 seconds
8d. click the 80 button, and wait 5 seconds
9. On the Configuration window's General tab, uncheck the "Log debugging info" box
10. attach the errorlog.txt file from your Commander folder to an email message, and send the message to me via
aa6yq (at) ambersoft.com
? ? ? 73,
? ? ? ? ? ? Dave, AA6YQ
