Re: Cannot get Commander to Connect to SDR
|
+ AA6YQ comments belo-w
Dave, we are again configuring our remote station that is using Starlink.? We have smartlink up and running and we are slowing trying to integrate DX Labs back into our home computer.? We are starting with Commander and we have an issue that I will try to explain.? I have configured the General Tab within Commander Configuration with the IP Address of my home computer, and listed the IP Port as 4992.? The Radio setting is SDR-6500 and the Command interval at 200ms with Span Dwell of 10.? I did type in the serial number of the remote 6500 but understand that is not needed.??
When I hit "Reset", the VFO B comes up with a frequency of 14257.20 and the VFO A reads the remote radio.? The problem is it does not appear to be "synced" with the SDR software as when I change the frequency on the radio from my SDR software on the home computer, it does not move the frequency in VFOA.? If I hit reset, it does change the frequency.? It is if it is not updating.? I know this is not right but I have exhausted what other changes I need to make.??
We are slowly working to get DX Labs work so when we work a station, it will automatically log into Keeper.---but got to get past this hurdle first.
Any ideas?
+ My 6500 is directly connected to my PC via an ethernet LAN; Commander controls it correctly. Based on feedback here, everyone else with a Flex Signature directly connected to their PC has the same experience. + I am not familiar with SmartLink; there is no support for it in Commander - if specific support is actually required. Perhaps someone here with SmartLink experience can help you; if not, try Eric KE5DTO at FlexRadio. ? ? ? ? 73, ? ? ? ? ? ? ? ? Dave, AA6YQ
|
