+ AA6YQ comments below
I'm having an issue with Commander controling my two radios.
I'm running a Ten-Tec Orion 2 and a Kenwood TS-890.
Whenever I select the radio button to move from the Orion 2 to the TS-890, after a few seconds the TS-890 goes into transmit. When I go back to the Orion 2 the TS-890 returns to receive and I can operate the Orion 2. If I select the TS-890 again she goes into transmit until I go back to the Orion 2.
If I turn off the TS-890 then select the TS-890 in Commander and turn the TS-890 back on again I can control the TS-890 fine until I swap back & forth between the radios again and the TS-890 will go into transmit.
Any ideas. I must have messed up my Commander configuration.
+ Please do the following:
1. place your TS-890 on a clear frequency, and reduce its RF output power to 0
2. make a screenshot of Commander's Configuration window's MultiRadio tab, and attach it to an email message
3. select the radio button to move from the Orion 2 to the TS-890
4. make a screenshot of Commander's Configuration window's Ports tab, and attach it to the email message you created in step 2
5. select the radio button to move from the TS-890 to the Orion 2
6. send the email message to me via
aa6yq (at) ambersoft.com
73,
Dave, AA6YQ
