开云体育

Did you change the setting in the “Single Label Orientation” panel as suggested?


73,


Dave, AA6YQ


From: dxlab@... [mailto:dxlab@...]
Sent: Saturday, March 05, 2016 2:57 PM
To: dxlab@...
Subject: Re: [dxlab] QSL Labels or Cards





SO with Single label selected.
Printer set to Landscape or Portrait Printing
If I set it for Height 1.1 and Width 3.2 I get "Specified column 1 offset is too larg (maximum is -2.203472 inches)" The view is still wrong. It shows the printing as horizontal. The label is shown as vertical.
If I set it for Height 3.2 and Width 1.1 I get I don't get a message. The view is still wrong. It shows the printing as horizontal. The label is shown as vertical.


SO no matter how I set it up, it fails to print correctly.

Select QSL Card:
I found a driver that seems to appear to work in other programs and gives me the QSL Card as an option. Card is setup as Width 3.5 Height 5.5. I have the printer selected, the sized selected and source selected in QSL configuration - Printer.

I have Printer QSL Cards and preview checked, I get "Specified QSL Card width is too small" essage. When the preview starts up, it Width at 10.653 x Length 8.152.

Since I can't get the DXKeeper to print labels correctly, I am guessing cards are going to be the same issue....

Will WC2L

On 3/5/2016 12:54 PM, 'Dave AA6YQ' aa6yq@... [dxlab] wrote:

AA6YQ comments below

-----Original Message-----
From: dxlab@... [mailto:dxlab@...]
Sent: Saturday, March 05, 2016 12:31 PM
To: ' Dave AA6YQ' aa6yq@... [dxlab]
Subject: [dxlab] QSL Labels or Cards
I was trying to get a few cards and or labels done.
When I preview a single label, it always shows the printing as horizontal. The label is shown as vertical. The printer is a Dymo LabelWriter 450.

In the "QSL labels and address labels" panel on the "QSL Configuration" window's Printer tab, change the setting in the "Single- Label Orientation" sub-panel.

I don't see the Avery 4150 as an option (labels I have).

That's a function of your printer driver.

With printing directly on the cards, it does not see the custom paper type I have added to the print engine.

That's a function of your printer driver.

If I select 3x5, all I get is different error messages depending on what I choose. I am using a Brother HL-5250dn.

Without knowing what the error messages say, one can only guess: try selecting a larger paper size.

73,
Dave, AA6YQ
------------------------------------
Posted by: "Dave AA6YQ" <mailto:aa6yq@...> <aa6yq@...>
------------------------------------
------------------------------------
Yahoo Groups Links