On 2/26/2016 8:07 PM, peter@... [dxlab] wrote:
+++ Comments below
+++ I do not plan to run NaP3 with N1MM. For contests, my plan is N1MM+
+++ and Skimmer only with Bridge and the LP-PAN running.
If you do not plan to run NaP3 with N1MM, configure NaP3 to use the
Secondary CAT Serial Port in Commander as shown in the fourth block
diagram here:
"SDR Console" is NaP3 and the SDR USB leg is the third sound card
(audio feeds both NaP3 and Skimmer).
Once you do that, CW Skimmer/OmniRig can get frequency data from
the 2nd CAT port in microHAM Router, NaP3 gets frequency data from
Commander and either Commander or N1MM+ can use Router's CAT Port.
You will get rid of LP-Bridge all together.
+++ That's what I figured. Believe me, if I could get rid of the
+++ Bridge I would in a heartbeat.
Above, QED. The information is all in the various manuals (microHAM
Router or DXLab Suite WiKi) if one takes time to read and understand
them. Just be sure you adjust the polling intervals in both NaP3 and
OmniRig as large (slow polling) as you are comfortable. I find both
work reasonably well when polling about once a second.
73,
... Joe, W4TV
