Tom,
The radio sends data
- if its "CI-V Transceive" setting is on, and you change frequency or
change modes
- in response to a query from Commander
If you didn't set "CI-V Transceive" to "on" (using the 746 menu, as
described in the manual), then you must configure CI-V Commander to
continuously query the radio by checking the "Continuous Frequency and Mode
Interrogation" box in Commander's General configuration tab
Alternatively, you can set "CI-V Transceive" to "on", in which case
continuous queries are unnecessary
If neither of the above configurations results in Commander displaying your
radio's frequency and mode, let me know and we'll take the next step - which
is to check the message window.
Just in case: do you have a scope or meter?
73,
Dave, AA6YQ
toggle quoted message
Show quoted text
-----Original Message-----
From: Tom Brouard [mailto:stagehand@...]
Sent: Tuesday, April 10, 2001 19:32 PM
To: Dxlab
Subject: [dxlab] Icom RS232 interface from KG7SG
I am running CI-V Commander version 1.2.2 using the KG7SG interface I just
made. I am able to control the ICOM 746 via the computer but I am not
able
to receive any data from the radio.
I have double checked all wiring and software and radio config settings
with
no luck.
I am still suspicious that it is in the wiring but I am hoping that it is
something simple in the software or at the radio that I may have
overlooked.
Suggestions from any is gratefully welcomed
Thank you
73 de KB2VNB
Yahoo! Groups Sponsor
To unsubscribe from this group, send an email to:
dxlab-unsubscribe@...
Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.
