it's use the paralel port as the printer.
I can send you the program
-----Oorspronkelijk bericht-----
Van: Dave Bernstein [mailto:dhb@...]
Verzonden: dinsdag 20 maart 2001 22:12
Aan: dxlab@...
Onderwerp: [dxlab] Re: DXKeeper new capture window.
If there's documentation for the RS232 command set, then yes its
possible. I checked the web site but didn't see this documentation.
If you have it, please forward me a copy.
73,
Dave, AA6YQ
--- In dxlab@y..., "Ron Eberson" <zx@c...> wrote:
Yep thats good
Is't posible to use the modem and software for EA4TX rotor control?
see ,ea4tx.com
this is not a comurcial bud i run this and like it.
Ron
PA1ZX
-----Oorspronkelijk bericht-----
Van: Richard B Drake [mailto:rich@w...]
Verzonden: dinsdag 20 maart 2001 18:46
Aan: dxlab@y...
Onderwerp: [dxlab] DXKeeper new capture window.
Dave,
I have been trying the new capture window and like it very much.
This morning, I got the run time error from CI-V commander without
WinWarbler running. What I had open was CI-V commander, DXKeeper
(with the new capture window) and DXview. One small change of
frequency from the radio dial and up came the error. It's not
consistent though, I can't reproduce it at will.
-----
73, Rich - W3ZJ
www.w3zj.com
To unsubscribe from this group, send an email to:
dxlab-unsubscribe@y...
Your use of Yahoo! Groups is subject to
To unsubscribe from this group, send an email to:
dxlab-unsubscribe@...
Your use of Yahoo! Groups is subject to
