开云体育

Don't lose hope. They were loud on 10m a little while ago but working EU. I scored Chad for ATNO and two bands yesterday with someone else's L7. This one suffered a flashover in a Chinese 3-500z a

A golden screwdriver even less so. 73 -Jim NU0C "Mike Bryce via groups.io" <prosolar@...> wrote:

Yes his xyl still sells the files but not CD’s. The info in his web site is good. Just send an email 73, Jim VE1RB [email protected]> wrote:

I just ordered 10 turn pots for the power supply board from Mouser.? Seems that if I just look at the damn things they change so a bit over $35 shipped will be well worth it IMO. 73, Bill NZ0T

Hi, I wanted to purchase the Drake 2-B info from K4OAH, but I found that he's an SK. RIP,? Garey. Did anyone continue on supplying Garey's Drake rig information? 73, Larry? K3PEG

Both of the Parasitic Choke resistors were kind of burnt. That may be because of parasitics as C39 and 40 were the blown capacitors. I don't think the breakers blew as it seems when the caps went I

Peter Thanks for the info, ok on it being for the RR1 RR2. Great picture of the LN4 in the RR1. Sure don't remember seeing anything like that. I was not that familiar with their marine line products

Must have been the same old tech that told me, “A screwdriver will never fix a broken radio.” Mike, WB8VGE SunLight Energy Systems The Heathkit Shop http://www.theheathkitshop.com/ J e e p

Bob, Could you provide a few extra details? Were all of the parasitic choke resistors "fried"? ?If so, that might be symptomatic of a self-oscillation or parasitic. ?. ?With the strapping as a DC

Sounds like a plate-grid short. Check the tubes for shorts. Check the plate choke to see if it opened. Look under the chassis and check the grid chokes. In the power supply check the .82 ohm resistor

Earlier this evening, while trying to tune my L7 up on 15 meters, there was a large flash and bang.? The L7 went dead and alot of smoke came out.? Opened it up and found the 47 ohm plate resistors

An old tech once told me that "it's almost never the alignment". If it is equally deaf on all bands you have a fault in the common parts. Follow the signal chain and see where you lose it. 73 -Jim

The jumper made no difference. It appears this rig just is a little deaf. I am going to see if I can return it. Ed

Or temporarily connect a male-male RCA cable between the rear panel EXT RCVR and EXT ANT jacks.? With the RCA cable, capacitive coupling is still maintained through C702. If the receiver comes alive,

Thanks for the info. I think I will let this mic go and try to find something better. I will dig into the manual and have a look at that jumper. 73, Ed KG5UN

Check that the internal RX antenna jumper has not been removed (Item C. on page 3-2 of the manual). Your 600 Ohm mic may not have enough output. The manual specifies a high impedance mic. You would

You are the winner of this thread. "Steve Wedge, W1ES/4 via groups.io" <w1es@...> wrote: -- 73 -Jim NU0C

*** That reminds me of a deal I got on a Galaxy V transceiver. It was absolutely mint condition. The flea market vendor said that he had removed the packing tape from the tubes. Lacking a power

Bad solder joint, open solder joint.

Yeah, I guess you're right! Links always look pretty strange....... -- *73/Rick* *W4XA * * Every post is created using Linux * *