开云体育

Ooops - missed a word! Use Ohm's Law to calculate what the current really is in each tube. The bias reading is the total of the measured voltage/resistance and then calculated *current *across each

Ferris: The best way to set the bias is to measure the voltage drop across each cathode resistor after checking the ACTUAL resistance of each of those two resistors (3 in the TR-series transceivers).

I would not trust the meter.? Drake used very cheap meters. The pointer may be stuck or the zero may be off.? I don't think these meters have an external zero adjust.??Sent from my Galaxy

The meter needle in my T4XC has a resting stop about a mark or so up from 0. SEE THE ATTACHED PHOTO. This occurs when the rig is both off and on. I have set bias according to the manual; adjusting the

Interesting. That is not an early one so perhaps it's my memory that's at fault. Steve Wedge, W1ES/4 Time flies like an arrow. Fruit flies like a banana. Sent with [Proton Mail](https://proton.me/)

Look below sn 6056 a Frank PA2FA

Definitely a fine example! I don’t ever recall seeing one with the chassis markings for the jacks and controls on the right side like that. What is the serial number? Steve Wedge, W1ES/4 Time flies

That copper sure is clean, no mung at all, that I can see! Joe – W7RKN From: [email protected] [mailto:[email protected]] On Behalf Of frank kloos Subject: Re: [DRAKE-RADIO] Newbie with TR-3

The R-4C is pending. 73, Steve Wedge, W1ES/4 Time flies like an arrow. Fruit flies like a banana. Sent from Proton Mail for iOS

Two pictures from the inside. After searching through my gear I found a Shure 401a microphone and it works very well with the drake. I get good audio rapports . Frank PA2FA

Steve, I would like this radio. KJ7AJ Bob Coffman 2drestoration@...

Has anyone done something like this with an early TR7 product detector? I'm aware of the MC1496 mod, just considering an alternative. 73 -Jim NU0C "Rob Sherwood" <rob@...> wrote:

https://yhst-172765969-1.stores.yahoo.net/drake-4line-crystal--hc6u-hold46.html Jim W7RY

AF4K Crystals has ANY Drake crystal you could need in stock on their web site. Look em up. 73, Jim W7RY -- Thanks and 73, Jim W7RY

RG-174 is 1/8 inch diameter, very flexible, easy to install onto phono plug, and capacitance is 30.8 pf per foot according to Belden spec sheet. Chuck N0CW

Additional note: All of the patch cables I use on C Line twins are made of this cable and operation has been great. Have made over 5000 SKCC QSOs in the past two years with this gear along with plenty

I have been selling off some Drake equipment for a friend of mine who hasn’t used any of his Drake stuff in years. When I get them in, I put them on the bench, clean switches and contacts, perform

I have an assortment of HC-6/U R-4C crystals for non-ham band frequencies. If anyone is interested drop me an email direct to rob@...<mailto:rob@...> $25 + mailing. Sent: Friday, February

Brian Carrick writes: Oh good grief! Why didn't that show up in any of my searches? :-P Thanks for the pointer. I'll soon have the whole set :-) --lyndon

I have a few in that type of holder. 25.6 25.0 24.5 In Megs. Also 10.0 m 4.5 m 4.915 m 11.0 m Cheers Cliff