开云体育

Notice: I have decided to turn over my supply of TR7 connectors, cable and crimp tool to Steve WA4F. Except for one local Colorado ham who may come by my house this week, Steve will supply these items

Thanks, Johni was going to do the calculations but it’s not easy when in the passenger seat of a moving car. :-) I figure that it took 61 years for the part to drift that far, so any corrections

If you can shunt your pot (fixed end to fixed end) with a made-up series combination of fixed resistors that yields about 35 megohms, you'lll be able to bring your 26 meg pot down to 15 megs. 73 de

Bob: Glad you got it out. The MN-2000 and MN-4 can be a bear to remove from the cabinet. Same with the C-4 console, especially if someone has replaced the inner cover screws with round head screws, or

It could, if you use a large piece. Steve Wedge, W1ES/4 Time flies like an arrow. Fruit flies like a banana. Sent from Proton Mail for iOS

Bob's correct. It's supposed to be laying against that metal coupling on the shaft. Probably has lost its spring over time. Mark, WB0IQK

Hi Gary, Does the paper on top of the finals affect their cooling? 73's Jim KD0WF

And yes it is built like a sherman tank

Well after a lot of trials and errors, I found that whomever placed it back in the cover put it on with the 4 outside screws for the case already installed. This is what was making it very difficult

Ah, that's where everyone was. I was hoping for a critical audio report on a "new to me," TR4-CW-RIT that followed me home. I also have no VOX on SSB and no delay on CW regardless of how the VOX

Steve's technique is the same I used to whiteline literally hundreds of R390A knobs. With Drake knobs, a trip to the hardware store for some "Blue Magic" polishing compound and a 30 seconds on a

Jerry, It depends on propagation. ?We've had checkins (not today) from Florida, Texas, Oklahoma, Minnesota, Michigan, Maine, Delaware, etc. but propagation holds all the cards. ?The time does not

Correction… not ALL 4-line boxes have ONE rolled edge on the front of the cabinet as rcvrs an txs have rolled edges front and back. The MN-2000, MN-4, CC-1, C-4, W-4, and WV-4 all have rolled edges

Bob….just thought of something else. There should be a rolled lip around the edge of the front of the outer cabinet. Wonder if someone put it in backwards????? The rear of the cabinet has NO rolled

Jerry, Yes, it does change relative to UTC, as it remains 1600 Eastern (whatever) time. Steve Wedge, W1ES/4 Time flies like an arrow. Fruit flies like a banana. Sent from Proton Mail for iOS

I checked into the Sunday net today and Jeff, WA8SAJ, suggested that I check the RF GAIN pot. This is a 15M (!) pot and is not very easy to find, these days. I measured the pot across the entire part,

Bob Do not remove the front panel screws! Put the feet back on their screws. Not going to be easy now but you should try and get the feet started on the thread, then pull on it to keep the screw from

I assume it slides out the front of the unit. But it is really tight.

I have the feet off. The screws that hold the feet are still in place tho.

Take the feet off. Gary W0DVN