Thanks Jim for the ideas. I had started the alignment and when I got to the BFO I could not get the frequency down to the correct frequency. So I am going to order a new crystal and replace iut?and hope for the best so I will eventually complete the alignment. I should have thought of that.?
On Sat, Jan 4, 2025 at 9:03?PM Jim Shorney via <jimNU0C=[email protected]> wrote:
First thought was that you have the Calibrator button depressed but that should be obvious because you could tune away from it with the VFO. As much as you have been digging around in there you may have knocked some adjustments off. I would do the frequency alignment starting at section 3-1 (10V adjustment) and proceeding through section 3-6 in the service manual. The fixed passband pots in 3-6 are particularly prone to getting bumped and some ops have replaced them with 10 turn trimpots. But I recommend the full frequency alignment so you know everything is correct.
On Sat, 4 Jan 2025 17:38:15 -0400
"Jim Harris via " <radiove1rb=[email protected]> wrote:
> yes it was a very pleasant surprised when I turned it on and it worked, The
> problem I have now id that when i SWITCH FROM lsb OR usB TO cw i get a
> signal in the receiver 5 over 9 and if I press the morse key I hear the
> tone as well. It does not seem to mute that signal. I also noticed that if
> I use the PBT I can hear a tone and can swing the passband and I can go
> back and forth past it. Almost sounds like an oscillation. Any ideas?
> Thanks,
>
> Jim VE1RB
