¿ªÔÆÌåÓý

ctrl + shift + ? for shortcuts
© 2025 Groups.io

Re: L4B vernier drive


 

Stan,

If I remember correctly, I ran into the same problem a couple of times. ?Soldered a piece of brass tubing from the True Value hardware store and it worked fine.

73,

Evan, K9SQG

On Sunday, December 31, 2023 at 05:42:56 PM EST, Stan Gammons via groups.io <buttercup11421@...> wrote:


Hi All,

I finally got around to taking my L4B off the bench and work on
replacing the vernier drive on the plate cap.? Looks like the one
referenced in the doc on the WB4HFN site

isn't the right one.? The shoulder where the pointer slips over is too
small. .340" versus .374" on the original vernier drive.? So, what to
do?? Try to repair the original vernier, which slips, replace the
vernier with a short coupler and shaft?? Ideas?

HNY


73

Stan
KM4HQE









Join [email protected] to automatically receive all group messages.