That knob should most certainly operate with a click at each position, allowing reception of AM, USB and LSB/CW.
There are two possibilities. One is simple, that the set screw for the knob is loose. I think this is a setscrew type knob¡
If the set screw is very tight but you still cannot get a switch action, remove the knob and have a look at the shaft. Try to turn it gently with a pliers. If you get the same result, remove the cover and have a look at the coupling between the small inner shaft and the switch behind it to see if it is loose or broken. That coupling is below the chassis (underside) towards the back, with the shaft going between the coils of the bandpass filter coils.
Try that. If no joy, I have the last possibility you. Don¡¯t want to hear unless you are really good at repair work.
Gary
W0DVN
toggle quoted message
Show quoted text
On Mar 20, 2023, at 8:28 PM, Dave via groups.io <kc3am@...> wrote:
Hello everyone,
Last summer I picked up a 2-C to go with my 2-NT.
I have been using it for CW without any troubles.
I tried to listen to some SSB signals tonight and I found a problem...
I cannot tune in the SSB signals, the mode control just spins around and has no effect.
This is the first time I have tried to listen to SSB so this is new to me.
Looking at the schematic before I open it up it looks like the mode switch should have a few positions to it and not just spin around.
Am I correct?
Thanks much,
Dave KC3AM
