The setup is as follows ,triplexer is a Bird ,with two cans for dd and four for dv. the hi side connected to xmit. port and the low side to rec Dv repeater on 1292.1 -20 .DD on 12523. Yes both are assigned to A and connected to proper ports .The dd port is connected to the only port available. on the dd repeater. Access to the repeater is thru a Id 1 . which works fine on A to C program (ID-1 to 880.) .I have proven the ID-1 out by a separate source ,freq are correct . Not sure if it makes any difference however a dv dongle on A does transmit . and rec ok. To do additional checks we hooked the mobile antenna directly to the repeater transmit side with no change . Have tried linking , E,I,U with no change. no other stations within range to try. Next is to change cable from controller, place SWR meter in line and see if any output. The ID-1 is within 5 ft of the repeater ,but antennas are 150 ft apart. The repeater is set to the curve from Bird frequencies .Have confirmed SN. with Bird and there is a match . Have tried on both hi and low power .If you need any more info please advise .Thanks Jim n8ovd 73
---- "rpttweaker@... [D-STAR_23cm]" <D-STAR_23cm@...> wrote:
toggle quoted message
Show quoted text
I think more details are needed. I am having a hard time understanding the setup. Please provide the following info.
TX Freq. Repeater output
RX Freq. Repeater Input
DD Freq.
Do you have both 1.2GHz modules assigned as A in the controller? Are they connected to the proper ports?
Have you tested with your ID-1 talking to someone on simplex connected to the triplexer?
Dave KA9WXN
KC9LKZ Tech Committee
