Roger:
?I don't have an environmental chamber at home, I only have a hair dryer!.
I didnt temperature test. I did cobble the circuit using three 5.1V zeners( I did pick up the 6.2V Rohm zeners but didn't use them yet)
I think the over size MOSFETs (2SK3563) are causing issues because the regulation is not stiff, it still rises about 100V over 900V as the Vcc raised past 900V and up to 1150V.? Again, if I tie the top end of the resistor divider to Vcc instead of the drain of the upper mosfet, regulation improves, and I see only about a 25V increase.?
I got to look for some smaller 100mA size 1000V mosfets. Unfortunately I haven't found anything that uses every remotely close in the e-recycling bins! Most items have mosfets in the 200~ 500V range at several to tens of amps.
P
