I had found a Birdgprot II with low voltage board problems and was going to
ask what it would take money and time wise to put in a new set of controls.
This post prompts me to finally ask - and also ask what system would you
guys install?
Chuck Merja
Elliot,
I'm within easy hauling range of Goleta, but I have to wait a few
weeks until I save up enough money for a funeral. My wife would kill
me if I bought another mill.
Marv Frankel
Los Angeles
I'm suprised it hasn't gone already.
All you read are posts about people whinging about "I can't find a mill etc.
" and when one pops up they convieniantly ignore it then post later "I wish
I had known"
Read it again.
Bridgy with all the guts ripped out saving you the hassle.
Chrome ways, ballscrews etc etc.
Then throw in a 4th axis and tooling and at $400 you have stolen it.
