That what I am using on my full size mill. Except that the PRM is up around
1200 and the current is a bit higher. I am running two to 1 timing belts on
the X and Y axis and 3.5 to one on the kneee. I simply chucked up the drive
shaft and drilled the oposite end for a .250 hole, then press in a stub
shaft and then mount my encoder. Works slick.
Dan
toggle quoted message
Show quoted text
-----Original Message-----
From: Tim Goldstein <timg@...>
To: CAD_CAM_EDM_DRO@... <CAD_CAM_EDM_DRO@...>
Date: Saturday, June 12, 1999 11:13 AM
Subject: [CAD_CAM_EDM_DRO] Servo motor question
From: "Tim Goldstein" <timg@...>
I was just a local salvage yard and they had a few DEC Magtape units that
had what appeared to me to be servo motors to drive the tape reels.
My question to you servo guru's (Matt, Jon, & ??) are these motors of any
use for a servo setup? The marking were DC Motor, 24 v. 0.5 amp 600 rpm
assembled by Indiana General.
Tim
[Denver, CO]
------------------------------------------------------------------------
ONElist members are using Shared Files in great ways!
Are you? If not, see our homepage for details.
------------------------------------------------------------------------
welcome to CAD_CAM_EDM_DRO@..., an unmodulated list for the
discussion of shop built systems in the above catagories.
To Unsubscribe:
bill, List Manager
