Peter,
Give me about a week to get my x-y plasma table finished. Then I
will be very interested in going over issues like the one you described.
I used DeskNC for about a week on my R-theta tubing notcher without
any noticible issues. But I had to remove the motors to build the x-y
gantry.
As a side note, I must give praise to Carl at DeskNC. During the
construction of my R-theta machine he was emailing me almost
instantaneous responses for more than a week to help with my problems
(and I am not a paying customer). I intend to buy a copy of DeskNC even
though I may move to other software for future machines. Check's in the
mail Carl.
