Art,
Just wanted to tell I have been looking at your website, great
pictures!! It really helps to visualize your setup as you have been
discribing it on the list. I hope my DRO turns out to be half as good
as yours.
Just a quick update from my shop, I didn't have any 7414's or the
decrete transistors that Steve Linsay used on my bench so I just
played around a bit. Hooked up the encoders to my scope and checked
out the waveform and then used a freq counter to do the same. All the
encoders look like they are working fine so after work tomorrow I
will pickup some chips at Radio Shack and put together a board.
Concerning the discussions about wires/cables for the setup, I have
lots of good parts left over from a dearly departed HP plotter.
Amoung the goodies are all the wires used to move the pen holder, I
think they will be long enough for the Y and Z axis' of my mill/drill
if not the x axis.
As I was playing with the encoder still hooked to the motor and
reading it with the freq counter, I realized that just one channel
out of a 1000 line encoder is a very nice division factor for a
tach????. I think I will experiment with that a little also.
Thanks again for sharing your experiences and your website!
Terry May
