At 09:31 PM 02/24/2000 -0800, you wrote:
From: Joe Landau <jrlandau@...>
Art,
I didn't find any of those bearings at the goldmine. What
do you use them for--are they holding the idler pulleys in
your setup?
I have two axles. One has the encoder wheel on one end, then a bearing, a
space for the cable, then another bearing. The other axle has just a shaft
with the space between the two bearings. No, the OD of the bearing does not
matter and you will only have to change the dimensions of your blocks to
accomodate them. Obviously, the ID needs to be the diameter of the shaft
that you use. I chose to keep the shaft OD the same as the ID of the
encoder wheel as it made things a lot easier to build and assemble.
If this is the case I guess the dimensions are
not critical, and another bearing would do just as well. Or
am I missing something?
NOPE!
Art
OLDER THAN DIRT
Country Bubba
(Actually the inventor of Country and Bubba)
