Hi!
I am running DeskNC on my step/dir servosystem from Dan Mauch.
I am running at a speed of 4000mm/min that is 157ipm.
I have been running files that takes up to 3 hours to finish and without errors.
My machine is a 133mHz Compaq notebook.
The resolution is 2000 pulses for 10mm (~3/8") or 200 steps /mm.
Ernst
----- Opprinnelig melding -----
Fra: Tim Goldstein <timg@...>
Til: <CAD_CAM_EDM_DRO@...>
Sendt: 25. februar 2000 22:00
Emne: Re: [CAD_CAM_EDM_DRO] is my software stable?
toggle quoted message
Show quoted text
From: "Tim Goldstein" <timg@...>
I don't want to fault the software, but the problem I was having did go away
when I changed to EMC. When I was cutting a circle segment at a low speed I
would frequently lose steps on the X axis. If I just made linear moves I was
OK. It seems in the circular moves I was hitting and trying to stay at some
speed that the combination of motor, machine and software just did not like.
As I have said, once I moved to EMC with no other changes I was able to make
the same cut without any loss of steps.
As far as the question of whether you will have a problem or not, that is a
good question and only time will tell. I can tell you that on my machine 18
ipm was about the best I could get reliably with DeskNC. On EMC with the
frequency stepper driver I can get 72 ipm reliably and am running it at 60
ipm just to keep some cushion.
Tim
[Denver, CO]
----- Original Message -----
From: Joe Vicars <jvicars@...>
To: <CAD_CAM_EDM_DRO@...>
Sent: Friday, February 25, 2000 1:31 PM
Subject: [CAD_CAM_EDM_DRO] is my software stable?
From: Joe Vicars <jvicars@...>
I am running desknc from a 486 DOS only machine. So far everything
works great, but the longest program I have run is less than 30 seconds
total. Eventually I want to run more complicated paths, and much longer
execute times. Am I going to run into stability problems from the
software?
------------------------------------------------------------------------
Get one email address for all your friends!
Start a free email group on eGroups!
------------------------------------------------------------------------
Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems in the above catagories.
To Unsubscribe, read archives, change to or from digest.
Go to:
Log on, and you will go to Member Center, and you can make changes there.
For the FAQ, go to
bill,
List Manager
------------------------------------------------------------------------
FREE ADVICE FROM REAL PEOPLE! Xpertsite has thousands of experts who
are willing to answer your questions for FREE. Go to Xpertsite today and
put your mind to rest.
------------------------------------------------------------------------
Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems in the above catagories.
To Unsubscribe, read archives, change to or from digest.
Go to:
Log on, and you will go to Member Center, and you can make changes there.
For the FAQ, go to
bill,
List Manager
