At 8:13 PM -0500 11-03-02, Carol & Jerry Jankura wrote:
I'm running TurboCNC into Camtronics 2 amp drivers into Sherline's 100 oz-in
motors. The power supply is a 24vdc regulated supply that's turned up to
around 26->28 volts. I get 4500 sps on X and Z and 2600 on Y.
Jerry-
Very good! Is this the $400 driver on their website? Do you know what driver chips are used?
Are you using full, half, 1/4, or 1/8 step mode?
--
Bryan Mumford
Santa Barbara, California
