Alan
I did this same thing. The only problem that I encountered was if one of
the geckos was not powered it would drag the whole disable line down and
shut off the others. Found this the hard way!
Ray
toggle quoted message
Show quoted text
? ?From: "Alan Matheson" <hokianga@...>
Subject: Re:Wiring of ?gecko drives in a CNC controller Im Building
Subject carefully chosen so I'm within the groups area!
I have 4 Gecko 201 drives in a controller Im building. Does anyone know
if I can connect all the Disable inputs together and switch them to
ground using one set of contacts ?or must I switch the Disable line
from each drive to ground using a separate set of contacts.
I'm a little concerned in case the drives interact with each other if I
just join all the Disable lines together and let them float during
normal operation.
Alan Matheson
