开云体育

Now that the audio issue has been fixed, I proceeded with alignment of BFO and Frequency.? For the most part, after viewing multiple videos, I did the alignment mostly by ear.? It sounds good, and frequency appears to be spot on. On air reports are fine, both SSB and CW.

?

However, if I am on the Noon-Time-Net (NTN) 7,284 LSB, I notice if I go to USB there is no change in the audio.? Sounds just as clear as when in LSB.? If I use CW to check into the NTN, dial set at 7,283.30, same thing.? No change in the audio on either USB or LSB setting. ?Is that normal for this radio?? No other radio I own acts like this, thus the question.? Thanks, 73 Richard AG5M

Hi Richard,

?

The change does not take effect unless you adjust the frequency.? Try the experiment with a click-up and click-down in frequency after changing from USB to LSB and vice versa.

?

73

Evan

AC9TU

?

Richard,

If I remember correctly, the stock firmware requires you to change frequency before it switches to the new side band selection.?

-Gary

Hi Evan and Gary. Yes, you were right, that was it. So for now it appears the little beast is working as it should. It will be on the air tomorrow to shake out any cobwebs. All is looking OK - for now. Thanks for all your assistance. 73, Richard AG5M