开云体育

Vic, Wow, I totally forgot about that discussion.? I guess I am getting old and starting to lose some mental abilities.??Thank you for pointing that out.? It seems that there were two versions of

<grin> Evan, we've had this conversation

Thank you Rolan, see my reply to Evan. 73, Yvon AE7YD

I did flash it with the N8LOV and that is when the other problems (USB/LSB) started. I did the BFO calibration with no problem. The Frequency calibration was very close but then it went totally off.

The sBITX version 2 sounds like a great rig on paper and I would very much like to buy one, but this forum is such a mish mash of overlapping issues poorly identified that it is very difficult to

Here is something I ordered from Amazon. It comes tomorrow so I cannot say it is right or not? I measured the bitx and it seems like this will work? adada Hard Travel Case Fits Canon PIXMA TR150 /

Hi Mark, I like the bit about the xyl ''being away'' when the cat's away the dogs will play !! Know what you mean.. Yes, whenever you are ready I would certainly like a hex file.. catch you

Hi Bruce, Since you have a 'nice scope', use a 50 ohm dummy load and your in business.? Just measure the Peak voltage (Vpeak).? Power = (Vpeak^2)/100 Rgds, Gary

Evan, your note solved my problem. I didn't have to go into the source code, but when you mentioned that "an HDMI monitor without sound did not have the issue" I went to the monitor's controls (I'm

1. Update to the latest software. 2. Just delete your /home/pi/sbitx/data/hw_settings.ini and you are safe. Restart and you are good to go! - f

Art. The plan for V2 was always to support bigger and beefer processors. And that required a new Raduino. I have currently tested a V6 compatible format board with Raspberry Pi Pico, Teensy 4.0,

What are the risks and what mitigation is there for using the sBitX V2 without calibration? I got one of the V2 units before the May 4 fix. I've got a nice scope but not a power meter of known

See my QRZ page for a V5 inside of a Pelican-type box about 11" wide by maybe 7" across and 6" deep. It has 8 LiPo drill battery cells and lasts about two hours.? I imagine a similar plan could be

Has anyone found a case , pelican or other, to protect the v2 inside a backpack?

Still sounds like a tuning issue.? Should only hear a sideband signal on the LSB on the 40M band.? The tuning process for the N8LOV firmware is no different than with the stock firmware, except that

Yvon, Are you using the same Nano as the one where the original software worked? If you used a Nano that was not working before, you need to recalibrate and adjust the BFO.? Here is the process to

Thank you Evan, that was the problem. I did not have the 'old boot loader' version selected. However my problem remains, it is still offset in frequency by 1.5KHz on 40m, 3KHz on 20m and so

Hi Mark, is the KD8CEC V2 available now. ?? Have the original V1 version here. Using my V6 ubitx.. Great idea using an external 10 mhz ref for frequency calibration. My standard here has been the

In terms of frequency calibration (i.e. MASTER_CAL) in the code, I am really sold on beating against an external OCXO source such as: https://www.ebay.com/itm/314264235972 This runs on a 9v battery,

Great let me know when you join. I will make you moderator. That way you can make and changes you see fit. I was just trying to help out. I was the guy at Hamvention that bought the very last radio