开云体育

My feelings on this issue is that the IDC male header should have been put on the opposite side from the encoders. Barry Sent from Mail for Windows Sent: Wednesday, January 3, 2024 6:08

Preface: I know almost nothing about coding. My question is, how will the logging program respond to a 0(zero) report value since it is unsigned? David

Just submitted a PR to add a "+" sign to FT8 signal reports that are not negative (including the "+" for positive signal levels does appear to be the FT8 convention) The change is very simple to

I appreciate suggestions that others have posted. I repair transceivers for the ham radio community and have a large list of test gear in my shop (

I bet it’s something simple. It won’t be long before we have it figured out! after you figure something out it always seems simple, but when it first happens it’s very perplexing!! Gordon

Not all of my screen shots came through for some reason. Varying power levels don't matter. I paid for a warranty and am expecting the manufacturer chime in and resolve this issue..

My earlier thought was to remove the female ribbon connector and replace the ribbon cable with a ten conductor shielded cable soldered directly to the encoder board, then put that encoder into a case

Yes Dave, you are correct, the V3 board is on the top and the V2 board on the bottom. The V2 encoders where just barely holding on by about 2-3 threads, I was very careful not to to over tighten them

Interesting.? I had already eyeballed that situation and was planning to investigate further, but you beat me to it. I presume your photo shows the V3 encoders with the shorter threads on the top,

See also: link1 ( /g/BITX20/topic/98903542#102349 ) link2 ( /g/BITX20/topic/99777967#103269 ) -- Regards, Dave, N1AI

Forgot the picture. Joel N6ALT

The sBitx log file is created in a standard format called sqlite. I? know just about ZERO relative to databases, but I did find a linux program called sqlitebrowser that is able to open up and edit

When I received my V3 board a couple of weeks ago I just swapped the new board in for the old V2 board, leaving everything else in place. Everything has been mostly working until this morning, the

That might be an over-simplification of what I wrote.? I don't think I've made an extensive enough exploration to reach the conclusion that it doesn't work, all I've concluded so far is that it gets

For what it's worth: Most of the time mine shows SWR of 1.0. I am using an ATU-100 tuner, and when I switch bands and tune up, the SWR meter on the radio fluctuates quite a lot until the tuner

It sounds like most everybody's results are the same, the SWR meter does not work in V3. Joel N6ALT

Interesting.? I find with my V3 it is under-reporting the output power, two different external power meters report higher values than the internal one. Perhaps this (

Ashar, you say that "2. The other station replies back with your rst. Now that the reports are exchanged, you enter this in your logger and press the LOG button. The qso is logged." When the

@W9JES I completely agree with you. I only see the practice developed here, when someone needs help, then contact the forum. When I noticed in May that I had the same problem, I didn't even try to

The one simple potential fix is to reflow the connections to L400 through L403.? There could be an open circuit in one of the connections.? It looks like it is easy to get to the connection from the