开云体育

Right, Having read the replies, I deleted all the bits and pieces i had downloaded.... Then started afresh, I can safely say I have it cracked, V1.09 is loaded and running. Message on display says

Hi Phil, Normally compilation errors are the result of libraries missing or not in the right place. Can you post the exact output you received on the latest compilation failure? Also, the Wiki has

direct copy from Raduino V1.09 Sketch? ? ? The main chip which generates upto three oscillators of various frequencies in the ? ? Raduino is the Si5351a. To learn more about Si5351a you can

Have a Raduino I wish to load the V1.09 sketch to, despite help and spending 2 evenings trying, apart from blink the damn sketch just will not load. I get various error messages... Compilation

Quick answer: Yes I'd put a 0.1uF cap on both ends of the tuning pot wire. ? One at the tuning pot and another at the Raduino end. ?Both are from signal to ground. ?Any RF picked up in that tuning

Another quick question: DO I need the capacitor across yellow and purple when switching to a 10 turn pot or was that just for the single turn? Brian, K2BRZ

I agree with your email. Just tune into 7.200 daily. I think that clown on there got hold of grandpas old Viking Valiant!! w/Amp. Hope Bitx gets a break. I would bet there's BaoFeng uv-5r radios out

I hope this doesn't affect bitx sales since I haven't bought one yet.

From the article: ?" our concern is that the powerful equipment can fall into wrong hands and be misused. More importantly, these two-way radios can tune into any frequency including confidential

Funny that they'd enforce that rule against India (and possibly those Chinese HTs), but I have see it enforced at hamfests only a couple of times - and I was ticketed in 1980. For the first several

I wired an RCA connector to the PTT and use one of the push button switches I had. Glenn

Howdy all, thanks for the add to the group, I just ordered my kit on the evening of the 10th, I guess I'll find out. I haven't got a reply from them on my kit or a receipt.

I just assumed that HF Signals would either have or acquire the proper license. The article does mention "high power" and "2M", which is not our concern. However, I still thought I would bring it to

Thanks, de KB8HGW. [email protected]> wrote:

Basically the problem is that some sellers are selling ham equipment to non hams and creating a problem for us. The seller needs a license and they have to sell to a licensed buyer as per our

I suppose that the rule is meant for sales from outside to India thro dealer and agents. May not be for sales from India to world hams in kit form. econjack@...> wrote: --

All: I just saw this in QST: Telecommunications Ministry in India Orders Halt to Online Transceiver Sales | | | Telecommunications Ministry in India Orders Halt to Online Transceiver Sales

"glenn silver May 9?#26323??( /g/BITX20/message/26323 ) I am using a Koss CS-100 headset with the Bitx40 (2 1/8" plugs) plugged into the MIC and Earphone sockets. I get good

Somewhere around my home is a worn copy of a C programming guide book published by Que and written by some dude named Jack. It helped, as did K&R and a few others. Pick up several books by authors

I'll be there. Jack, W8TEE To: [email protected] Sent: Thursday, May 11, 2017 12:15 AM Subject: [BITX20] Dayton Hamvention How many of you Bitx owners are going to Dayton, Hamvention next