开云体育

Good Afternoon All; Just managed to accidently pull both ends of R5 pads off on pop-fix board. Is there any kluge that would work with a 10K TH resister. This is my very first smd project and I lost

Very nice.? Any hint on the connector wiring, please, Vves? Thanks. Eddie WA4JXL sorry for all these posts and questions.

Sunil, My case came with a 4 pin microphone connector, understand pin 4 is earth, any guidance on the other 3?? Only 3 pins are used on the front panel cb. Tnx. Eddie

The feature that is desired of ferrties and iron power for transformers is coupling as close as possible to 1.? Very hard to get that with air cores. However by building them as transmission line

Cute ... At least the people listening to you at the other end will hear a fresh voice.

More than a different cut... the 49S? nb S has a beam hogging mode of oscillation and the HC49U (13mm h) has a diaphragm mode. I thin we both speak Anglisky but? there is a slight confusion here on

There's some well established forums out there regarding antennas. Might be best to just decamp to one of those for things Maxwellian. I haven't looked them over much, any suggestions of which?

Hopefully it goes well.? I really do.? Having good information on antennas is great.?? ? I would rather be a moderator of a political philosophy group.?? I've seen a couple of groups on fb get

Very true Allison, Xtal prams will differ from manufacturer to manufacturer hence it is of out most importance that we characterise the xtals that we are going to use. Here in India I assume that the

I'm already moderating two other non-electronics groups. Sorry. 73 Ken [email protected]> wrote:

Especially those that want to talk about *Bitx*es in this forum. Jerry

Ken Either, or both work for me. Do you want to be a moderator as well as a member? Arv _._

Ken, and others... Just go to /g/antennas/ and sign in. Mail posts can be done from the group login or from email to: [email protected] This group needs at least a couple of

Sorry I thought it said member, not moderator.

I'd like to be a member Arv. Ken Chase VA3ABN Thanks

Thanks Arv.? I'm sure this new group will resonate with many of us. -- www.bitxmap.com ( http://www.bitxmap.com )

Thanks for starting that. Allison

Its 17.4 in free space for a perfect thin wire.? ?Multiply that by .95 for reality. If you used 234/f? (234 .25W is half of 468 .5W) you get 16.62.?? Even antenna wires have velocity factor.

A new group on groups has just been formed. /g/antennas/ It is for the purpose of general discussion of antennas and antenna designs. This is a relatively free-ranging group with

Allison, Thanks so much!? This is very, very helpful!? You have given me a lot of homework.? I will try the following and report back. * Install air choke at matchbox (20ft RG8X wrapped tightly