开云体育

Uploaded spectrum analysis at T10 ..Sample loop 4 turns through core to SA the absolute levels are uncalibrated however the relative levels should be ok Each of the two-tone oscillators is set to 100

too bad I can't spell this morning?? ...photo album is "ubitx T9 spectrum"

But.....IRF510 devices have not been made for International Rectifier for over 20 years. They licensed the die to a South Korean firm, who had them manufactured in China. Not sure where the Bulgarian

I've taken the liberty of uploading some spectrum analysis photos of rf in T9...two-tone test ..Each oscillator is set to 100 mV level

Bo you got a place holder but no photo kc2ipx

Here is the link for the latest uBITX Manager https://drive.google.com/file/d/1DF0ida-QkXQ12J9XOKE19mmOLr-GKnwo/view

If you are using the IDE to load the NANO make sure under "Tools" the "Processor:(OLD BOOTLOADER); rOn

Hello Mickael Many thanks for your mail. I also have a Sotabeam module filter (SSB/CW) that I was going to mount with an output LM386 module. Your editing shows that the LM386 is not absolutely

On Fri, 17 Aug 2018 23:19:33 -0700 "jfein2000 via Groups.Io" <jfein2000@...> wrote: Hi, I'm the other poster who had the same problem. I think we have been given bad Raduinos. I'll

Good morning Allison, ? Thanks again for all your help! ? I need some help with fine tuning the uBITX, I have a Grundig Satellite 750 receiver that I am using to find signals and then using my

Photos section

Thanks for the inputs! ?I'll try them. I'll ?not just check power out, but also the voltages ?/signals with my scope. And for heat too.? I'll put info on the nice socket pins in the files

I suspect those so-called IRF510's from Tayda are good enough if you plan to use them for their intended purpose. Specifically, for use as low speed power switches. To use an IRF510 at 10 or 20 mhz

Hi all, I am new here! I would like to modify the rx of my Heathkit hw-7 , leaving the original front panel and case. I like to use a simple Quadrature switching mixer , thus, eliminating the

Derek :? Regarding the SOTABEAMS DSP filters. I have a couple of the dual-bandwith ones. The General filter (2.5Khz/300 Hz) is installed in my BITX40 and the CW filter (1khz/300Hz)? in my uBITX.

It would be nice to know what is and is not good from Tayda as they have low prices and low cost shipping.guress sometimes you git what you pay for...

Hi Guys: I am looking for the newest version of the Ubitx manager and where to download it. Thanks and 73 Ross Bell K7RSB

Now that I've seen the difference between a uBITX Raduino and the BITX40 Raduino, I checked my stock and I can easily supply my Raduino Clone to the BITX40 users with the 5 pin "Molex" style plug to

On Fri, 17 Aug 2018 23:08:03 -0700 "jfein2000 via Groups.Io" <jfein2000@...> wrote: Hi, glad to hear I'm not the only one experiencing this problem. I'm wondering if the ADC in the

I just posted this issue as well before I saw this message on topic.? I have exactly the same problem.? Voltage does drop to zero when contacts are closed.? Has anyone been able to debug this issue