开云体育

It’s not an idiots guide, it’s a learning process. We’re all going through it, some have just started earlier. I went through this exact issue about a month ago. Best of luck. Enjoy! I hope we

I used this guide to get started but off from this site I was able to find the later releases: http://www.hamskey.com/2018/06/ubitx-with-nextion-lcd-cec-firmware.html?m=1

Greetings to all. I have two BitX40's in Universal cases for sale. The first is built and ready to go in the Universal Case DA Grey I and the other is unbuilt with the Universal Maroon Case II. Both

Hello, got my ubitx v5 one month ago, almost finished ... it's sell with "More than 10 watts up to 10 MHz, 7 watts up to 21 MHz, 2 watts on 28 MHz" , i get 2w between 21 an 30Mhz, then the power

Fantastic! Thank you Mike! Sorry for needing the idiots guide.

Whoops! My error, now discovered. Nothing like making a post for help to dicover the problem on you own! I assumed I had the latest DSPMeter sketch (v1) but it appears by looking at the upload dates

Would the (now discontinued) CW Conditioning Board (here) ( https://qrpguys.com/ubitx-cw-conditioning-adapter ) help fix this?? Seems easy enough to home brew this circuit.? Still waiting on my V6

I read your post that you have the SWR function working on your uBitX. I have a V4 that I built a year ago and added the Nextion display, then added the second I2C Arduino and I am able to do all

I would like one or two of these boards when they become available. thanks, Paul K0ZYV ________________________________ Sent: Tuesday, January 14, 2020 12:51 PM To: [email protected] <[email protected]>

I too would like one of these boards.

Dave, I’ll have to find out how to change that setting -- Bob NZ2Z

Legal risks are not something I would worry about, especially at QRP power levels. Cease operating if you get a complaint, verify your equipment is not at fault before resuming. If that's too much

Bill, Thank-you again.? i see that it is a "basic" 2.8" unit.? I know where to get the KD8CEC firmware for the Nano, are you saying that the source on Git hub had the tft file for the Nextion as

Likewise would repairing your own faulty ICOM or Yaesu gear not fall into the same category? Changing the PA's as an example could result in some nasty parasitics that could interfere with another

likewise I wondered about? remote amateur systems like echolink or teamspeak3 granting full transmit access to a basic or basic-plus qualified licensee from Canada

I used this one: Nextion 2.8 inch Display... https://www.amazon.com/dp/B07Q36RBV2?ref=ppx_pop_mob_ap_share And then loaded the kd8cec code on it and updated the firmware on the v6 to the v5 CEC

also found this: https://www.ic.gc.ca/eic/site/smt-gst.nsf/eng/sf01008.html#s4.1 “Build” in the context of the Basic Certificate is limited to the assembly of commercially available transmitter

I tried to re adjust the two bias pots by following the ubitx guide. It says to first turn them clockwise and measure the current, when doing this my total current consumption in 1.2A (some searching

I wondered the same thing, but apparently the ubitx falls under the " With Basic Qualification only, transmitting equipment must be either a commercial pre-assembled product or a packaged kit

I was a volunteer examiner here in Canada for our rural locale and Basic Plus gives a successful candidate access to all bands including? HF bands below 30MHz with power limitations and using