开云体育

I suppose I should address the cal stuff too. The main oscillator cal calibrates the frequency generator, which determines how correct all three of the clock outputs from the chip are. The BFO cal

Hi Dan, If you're using the stock software, you should be able to press and hold (for a LONG time, like 10s) the button after powering the radio on, and it will go to a config menu. You can then

Hello. Got my full kit (board v6.2 / firmware v6.1) the other day and assembled it this morning.Easy as pie. I managed to puzzle out (I think) how to get into alignment: hold tuning knob in while

Thanks! That’s a great price! Hows the ripple on that one Stephen? Right now I have a small 12volt storage battery hook up. Good pure DC. I charge it with a small 110 car charger. Jeff

Jeff, In case you need a power supply, I found a 5 watt, 12 VDC one (#PS-12005) at All Electronics for$10.95. It sure beats the nine D cells that I had lined up in a piece of PVC pipe! Stephen

My software does that (among other changes). https://github.com/reedbn/ubitxv6 Reed

Anyone know if there is a software mod to highlight the band currently selected? It is poor user operability if touching a button shows no action on that button. Jeff -- *jeff.debes@...*

Thank you Reed. That is helpful. This seems like a pitfall that should have been documented or warned against if the rig is improperly adjusted. On if I listed to WWV on USB and LSB: No, I did mean

Hi Jeff, Are you saying that you can hear a SSB transmission using either side band mode? WWV is an AM signal, so it would make sense that you would be able to hear it on both side bands. I know that

Sounds good, thanks.

That would be great! I've done some writing, too, and I know it's not easy, but I also know a lot of people would appreciate it. Jack, W8TEE

I paid $23.98 for “Barjan CB Amplified Loud Power ....” from Advanced Specialties Inc. on Amazon.

Jack, no, I don’t expect the same quality in the HFSigs as in my KX2. ( I said mistakenly KX3, but have the KX2) Jeff

Yes, in part that is what I did for a living . That and human factors/ operability in product design. I might volunteer do do that. Jeff

Steven, How much was the microphone? Jeff

Hmmm...let's see...$1,271.60 versus $200, yet you expect them to be the same? Jack, W8TEE

Jeff What part of the documentation did you have trouble with? We can improve it only if we know where the problems might be. I think you said you could write better documentation...? Are you

Thanks everyone for the suggestions: So I followed the Ashar Farhan alignment video as best I could and I can tune in WWV at 10 mhz precisely zero beating the signal. I’m not at a place where I have

Evan, I ordered and just received the microphone with pre-amplifier that you suggested I buy. I also built a poor-man’s low power watt meter. To compare the new microphone with the original Baofeng

Aaron, I can think of 2 ways to reduce power when using digital modes.? The first reduces power for all modes via RV1.? That control can be adjusted to set the power for the rig.? The other choice