开云体育

Hi guys, Go to the ubitx.net website download section and click on VU3SUA case construction link. This will get you to a page with many pictures you can download to guide you. 73

I managed to calibrate the radio successfully. Once again many thanks for the great support, which I experienced here in the forum, I address in particular my thanks to Reed. My next step is to add a

I have a few different repurposed ?enclosures I might use. I am mostly interested in 40/20. I just have been away for awhile and wanted to find a package of wiring and fixes instead of running down

Due to the extension of the Covid-19 shelter in place, We will be closed until June 12th. I am very sorry about the delay but it is what it is. Be safe. -- David N8DAH Kit-Projects.com (

There is a way to show RX/TX.? That requires a resistor (I assume it is on the board) and connections to the K1 relay and ground.? You tap off of pins 1 for TX and pin 3 for RX.? That will be 12

Hi Evan, I bought the v3 a couple of years ago and then last year a cabinet from amateurradiokits.in. When the case arrived, there were extra parts and among them the little pc board and LED. I would

There was not an LED supplied with the HFSignals v3 uBiTx.? I assume that you have one of the enclosures supplied by third parties.? In order to provide correct information, it would be best to know

Good day to all, I'm almost finished assembling my ubitx v3 radio and in the manual (last page) it says to hook up the LED to the v3 ubitx board. I have looked every where on the board, on the

Hi all experts, I am trying to use the oscillator described in EMRFD book page 4.9 fig 4.13 C. I have attached a drawing here. Sorry for the bad drawing. The values inside the brackets are actual

We should be open and back to normal (mostly) Monday June 1st. We have plenty of kits and more will be made available as needed. 73 -- David N8DAH Kit-Projects.com ( http://www.kit-projects.com ) Shop

HI amie! I do not know if david has gotten back to you in email, But we have received it! That said we are currently closed and not shipping product due to covid concerns, We have some decisions to

Good catch Curt! I did not think of the AmatureRadioKits (even though I did repackage all of my uBiTx in one of them after first installed in a hacked project box of some kind).? That does change the

Good to see you worked it out. in future you can run a sanity check by visiting ssllabs.com/ssltest which checks certificates, TLS config and susceptibility to SSL-related vulnerabilities. hfsignals

I see Evan has pointed you to instructions at hfsignals, that apply if you use a self supplied case. If you happen to have a case from amateuradiokits.in there are additional instructions involved. I

John, For the type of information that you are requesting, I would go to the ubitx.net site.? That seems to have the most information on older uBiTx models.? Be sure to check out the "FIX" section,

AMIE, For the Nextion editor, try the Nextion Editor LTS version.? That is version 0.53 if I remember correctly.? For some reason that version will compile the 2.8" screens without the memory error

Search in Google

I finally have a place to work on my ubitx version 3.? Where can I find the connection information?? I don't see it on hfsignals.com anymore.? I remember there were a lot of mods and fixes for this

I got the V6 and got it all put together and going, so I thought. K3 is dead after trouble shooting and manually? adding the 12v needed it worked, so pulled K3 and borrowed Ka1 then added a jumper in

HF signals does ? -- *AMIE N9OXO*