开云体育

Cameron, As Stephen suggests, the first step is ensuring that the transmitter amplifier is working before looking at the SSB sections.? That is done on the v6 by selecting CW as the mode and using

If you get power output when pressing the PTT in the CW mode, more than likely it is the microphone. Based on my own personal experience, I highly recommend purchasing a CB microphone with a built-in

Seems like I am getting an extra dah and have had for years so I am trying to figure it out... -- Frank, KG9H

Maybe try to set it to CW mode and check for carrier power when keying the mic.

did you have transmit power before you made the modification? If so, how much, what mode, which bands? Gordon Gibby KX4Z

Hello anyone know where I can get a couple of raduinos from in the UK I got the Bitx40 and the v3 uBitx cheers….

Folks, I am looking backwards in time on the site, and I am trying to find the correct resistor combination for the two or three resistors for correct paddle function. I am also looking for the board

1st I posted am interference, a bci filter kit was recommended, so I ordered, put it together and installed on the trace. It improved the receive side, but I have not yet made a contact, so I hooked a

1st I posted am interference, a bci filter kit was recommended, so I ordered, put it together and installed on the trace. It improved the receive side, but I have not yet made a contact, so I hooked a

Thank you David, it sounds like you have a pretty great setup -- '72 Aaron K5ATG

The KD8CEC software is here: https://github.com/phdlee/ubitx/releases/tag/v1.20 You will also need the Nextion files.? Those depend on the Nextion size and model (basic or enhanced). There are tft

The case that I am using has almost the same front-to-back dimensions as the stock uBITX v6 case from HF Signals. What is throwing me off, is the BNC connector on the uBITX board sticks out on the

Pierre, Check line 382 onwards where the bandstack is defined. - f

I'm reinstalling a Nextion display. I do not remember what all I need besides the hardware. I have the uBITX Memory Manager and X Loader. I can't recall where to get the latest firmware to be able to

A new member of this group, I deeply studied formerly your documentation about uBITX v.6 but eventually decided to go clearly to SDR XCVR and bought a Hermes Lite 2, which I use with SDR Console v.3

Aaron,If you are installing into a bigger cabinet like what is shown, just get a 90 degree bnc connector to connect to ubitx and run coax to tuner with another bnc fitting. That way you are keeping

Not sure what I did differently, but after flashing with the flash download tool and restarting the Ubitx a few times, it works. I still need to solder the 100nf capacitor between the +3.3v track and

Aaron,I installed mine in a bigger case also but only later. I installed a ldg100 tuner into mine. I took the tuner out of the case and made brackets to hold it in place where the speaker sat. i

Thanks! I didn’t go down a level.

How can i reset mu ubitex v6 Rahul Singh VU3IXB vu3ixb@...