开云体育

John, An alternate debug approach: Start with the simple Blink example sketch. The LED on the Nano is on the same pin as SCK. This would be a simple diagnostic / sanity check. 50% duty cycle at 0.5

Frank, There is a low pass filter in the transceiver as shipped from HFSignals. This is set to reject any frequencies above 30MHz, so if it is an FM station, then a high pass BCI filter will not help.

Harness, volume control, ten turn pot, and associated cables. (We're having an ice storm, here in Texas, so if you want it,I'll ship tomorrow) (Use private email and I'm on PayPal) Cheers, Jim

Hi Jim…Thanks for the response…Are we talking everything in the picture (wiring harnesses, etc) or just the board itself?...Jim WB2LHP Sent from Mail for Windows 10 Sent: Thursday, February 11,

Mark see the attachment, might be the FM Broadcast station near you. If not that one, listen for a while to see what the station ID is. ?You probably need a broadcast filter. Good luck. Frank KG9H

Hi folks, that’s not really an end fed dipole is it? It’s actually a 23% off center fed dipole, isn’t it? That type of dipole was extensively reviewed maybe a year in QST or somewhere I read..

John, The receiver needs to be calibrate for both frequency and BFO. ?The calibration values are stored in the EEPROM of the Nano, so every time that you have it out you need to recalibrate. Without

I have an early one. $25 buys it.? See photo. Your mileage may vary, Jim W0CHL

On Thu, Feb 11, 2021 at 01:32 AM, Evan Hand wrote: > > John, > > Can you confirm that the Nano has been replaced and either the original > HFSignals (Ashhar Farhan) code is installed or Reed N,s code

John, Can you confirm that the Nano has been replaced and either the original HFSignals (Ashhar Farhan) code is installed or Reed N,s code is installed?? The link to Reed's code was given by him in a

I sure hope you were spared the apparent Leipzig layover... Kelly KD5AJ

haha..??? the details on my tracking show that my radio spent 2 minutes in FRANKFURT; arrived from BANGALORE at 22:46, departed 22:48. The next (most recent) line on the tracking indicates that the

Maybe there is light at the end of the tunnel that is not a train!? My tracking just updated and my package is now in Cincinnati! :-)

Mark, My Bad -- Somehow when I re-did the website, the BCB filter got left out. Here's the construction manual for it and I do have some PC boards available. Email me privately and I'll make you a

Very curious. Are you sure you are getting the correct code loaded into the Nano? Perhaps I am wrong to assume the Nano will write to the display, perhaps one of the other connections is hanging it

I find my End Fed Dipole does a fantastic job receiving all freqs the V6 will tune to, from AM broadcast through 10M. Details of it can be found here, also copied below. Link has more

Interesting.? ?I took the dipole I've been waiting to hang outside and measured a bit over 17feet on each leg.? ?I strung it up high inside the first floor of the house and connected to the radio

On Tue, Feb 9, 2021 at 11:06 AM, Jerry Gaffke wrote: > > John, > > I believe the screen should display something so long as connections from > Nano to screen are good, and the 5v supply is up. > The

I guess I'll be in the same boat with y'all - tracking says mine has departed Frankfurt

Mark, Check out TSW’s website, www.w0eb.com. Look for and click on the broadcast band filter tab in the top left corner. We have a couple PC boards for through hole and SMD versions of a really