开云体育

For your conversion consideration, BNC female panel mount with 0.72" holes on center are not common but do exist. https://www.rfparts.com/connectors/connectors-bnc/bnc-panelpcb/rfb1115-14.html Rgds,

Yes, find the resistor to the LED that provides the driving current for the lighting, and then increase its resistance.

Hello, I was wondering if there was anyway to control the brightness of the uBitX V6's screen? - Mike

So, start with the basics. Read the voltage on the push to talk pin of the jack, and see what happens to it when you plug that mic in. If it goes to zero, you are shorting it out somehow. Proceed

just got my uBitx V6 assembled, been listening to the receiver on 40m ,it seem to be OK.? decided to check transmitter out, when I plug in the Baofeng mic the radio goes into transmit. after doing

One piece - ready made... BNC Female Chassis Mount Connector - Square | | | | | | | | | | | BNC Female Chassis Mount Connector - Square 1 Piece | Female | Nickel Plated | Crimp Type | Chassis Mount |

Tom I looked at what it might take to make a D-hole punch. Seems that a 1/2 inch Grade-8 bolt could be turned to the desired diameter and one side ground flat to make the D part. Then turn the end

there are some creaky bones like us who are stull puffing the ol bitx20. this way before this city came up here. we'd hunt 'em nylon tap washers and cook 20 meters on nights of 2009 cycle. - f

Arv, I've considered making my own. I have a drill press and an arbor press. I've got a good set of greenlee hole punches (the bolt driven punches) but none that are d hole or that small (I think my

Mute This Topic: /mt/75262023/234805 It’s good to use the tools attached to the email where you complain about how to mute a topic.... Rofl

Perfect practical approach. [email protected]> wrote:

If you have a machinist friend it would be fairly easy for him/her to make a D-hole Punch for thin aluminum plate. Remember old bolt- driven chassis punches. Same thing works for punching D-holes. Arv

I make my own from scrap aluminum sheet. They have a regular hole in the center instead of a d-hole but as long as the?BNC?connector has a lock washer and is tightened down properly I have never had

Does anyone know of a source for these? I used to buy these from Oak Hills Research, however with Marshal Em's passing you can not order from OHR. It is just a plate with 4 screw holes spaced to match

The original poster is asking about his BITX20, not the ?BITX.? Farhan released the ?BITX design in early 2017.? It was first available commercially through HF Signals at the end of 2017.? His

Rajesh, First off, did you follow the suggestions in this message? /g/BITX20/message/80271 NOTE: Please ignore the typo Arduion, it should have been Arduino. There is only one file

Thank you Vic!? I did not know that was there.? I will need to give it a try. 73 Evan AC9TU

Hi, I looked around for the means to mute message threads by subject on groups.io. We apparently cannot do that but there is a hint that we *can* mute messages by their hashtags. I have added a

Evan, the CEC firmware allows WSPR in beacon mode for transmitting, but not decoding. You use the Memory Manager program to set your location (you can set 4 different locations), and frequency (3

Hi Thanks for the revert. I use the standard lcd display which comes with the box. Have uploadrd the corresponding hex files as well. But still the display does not light up. Since I have ver3 running