开云体育

Fantastic article Jack. Thank you for sharing it. 73 Murray ZL2IQ Rev Murray Wills Box 31-227 Lower Hutt 5009, New Zealand Sent: Friday, 27 March 2020 3:51 AM To: [email protected] Subject: Re:

Gordon, If you are looking at using a board with the Bosch BMP180 transducer the I2C address is 0x77. 73 Bob GM4CID

I received my V6 in 7 days after ordering it. That was about a week ago. Just got it working and I would definitely order one ASAP to avoid being put on a waiting list. Vy 73 Rich

Doc, I've used these utilities to scan the bus for existing addresses.? Good tools to have in the

Hi Rene, I think David may be correct.? Before you have said: Rene Feb 19 #76181 ( /g/BITX20/message/76181 ) I use 3x 18650 in serie with a 78h12....so 12volts and max 5A. Now?

Yah, I'd like to tell you my forfathers ?invented the Beverage antenna. ?I've investigated that but turned up little info on it's origination. ?I did have one when I was a kid building my own one

Just received mine by DHL a few days ago --no problem even here in Los Angeles county.? Of course things may have changed in India, in the last week.? Hope this information is still current.? Dave

I don't know the specifics in India right now, but I understand the 'kits' are assembled by contract workers who pickup parts, take them home, assemble them, then return them to be tested and shipped

Want to buy a uBITX V6. Just unsure if they are shipping at the moment with the current global situation. I emailed but have not heard back. Anyone on here know if they are operating now?

Thanks everyone!!

Hi Rene I have not see this suggestion given to you before so here goes.? Have you checked the power supply you are using, you need at least 3 to 4 amps for transmit, it is your power supply is

Gordon, the V6 display does not use the I2C bus at all. It is an SPI device, not I2C. The only I2C device is the Si5351 which uses I2C address 60. Jim, W0EB

When using version 1.110 on my v6 modified?with Nextion and CEC version 1.200 I had the same error. I did find however if I left the unit off and only connected the usb connection then it all worked

Gordon, The I2C is brought out on a connector (similar to the ubitx wire connectors). It has 5 pins : GND, +3.3v, 5V, A5, A4. You can connect any I2C device to it. More in an hour or so. - f wrote:

thank you! gordon wrote:

Consider his code: XPT2046_Touchscreen ts(CS_PIN); Adafruit_ILI9341 tft = Adafruit_ILI9341(TFT_CS, TFT_DC); The ILI9341 is usually associated with SPI interfaces, so doesn't use a slave

The tft display uses the SPI bus and not the I2C bus. The only conflict on the I2C bus I can think of would be with the Si5351 which is at address 0x60. Jerry

Could you not get the address from the github source code? 73 Evan AC9TU

same problem in my ubitx how can solve Error receive length = 0/1027

This is our draft of a Double-Double Mag Loop, which was just published in Rad Com. Note how it results in much higher efficiencies. Jack, W8TEE